TRI-TRONICS SMARTYEYE® MARK II with Infrared LED, potentiometer adjustment, 4-wire M12 Connector and F1 Fiberoptic Optical Block. 12 to 24 VDC Supply Voltage, polarity protected. The maximum range depends on fiberoptic.
Technical Features
| Model Specific |
Adjustment Type: Connection Type: Housing Type: Optical Block: - Type F1, Fiberoptic Adapter
Adapts a sensor to any standard fiber optic light guide with .187" O.D. tips. The light guide is inserted and held in place with a slide-action snap.
| LED Light Source - Infrared = 880nm
Recommended in opaque object sensing applications. Infrared LED light source provides long-range sensing in either Beam Make or Beam Break modes. Infrared light maximizes the sensor’s ability to penetrate contamination found in harsh environments.
Sensing Range: - Opposed Mode with F1: 3.5ft.
- Opposed Mode with F1 with Lens: 20ft. +.
- Proximity Mode with F1: 5.5in using a .125in diameter fiber bundle
- Proximity Mode with F1 with Lens: 1.5ft using a .125in diameter fiber bundle
|
| Family Specific |
Supply Voltage: - 12 to 24 VDC
- Polarity Protected
Current Requirements: Output Transistors: - (1) NPN and (1) PNP sensor output transistor
- NPN Sink up to 150mA
- PNP Source up to 150mA
- Momentary short circuit protected
- Outputs protected from pulsing during power up
- Light/dark switch de4termines output status
Light = Light "ON" operate
Dark = Dark "ON" operate
Response Time - Minimum duration of input event
- Light state response = 50 microseconds
- Dark state response = 140 microseconds
- Leading edge variation less than 20 microseconds
Hysteresis: - Less than 400 millivolts for maximum sensitivity and resolution
|
Mark-II-Instructions SEIF1, Tri-Tronics 
